Manufactured from Fibreglass designed specifically for your bike with a Chainguard incorporated
The Huggers are one of our trademark products designed specifically for your motorcycle and offering substantial added protection and individual styling. Where possible we incorporate protection that extends below the swingarm together with a built-in chainguard to replace your existing guard meaning that your shock absorber and chain are fully protected. Available in a wide range of colour schemes our Huggers will arrive safely packaged together with comprehensive fitting instructions and any additional fittings which may be required. No modification to your motorcycle is necessary.
We always advise the use of our Venture Shield protection film to minimise the effects of stone chips and cracking especially on painted products which sit low to the ground. Without Venture Shield fitted to these low forward facing parts of your bodywork then unfortunately damage from stones and other debris is unavoidable!
Legal Notice
The rear wheel cover offered here does not have a vehicle approval certificate/ABE.
Please ask your test engineer about individual approval according to §21.
Approvals are generally at the discretion of the test engineers and experts. However, they must strictly adhere to the StVZO (German Road Traffic Licensing Regulations).
Registration Required
Components or assemblies that require a vehicle approval certificate or a parts certificate and that must be entered in the vehicle documents. Exception: If the vehicle approval certificate is carried, the entry is not mandatory.
Intake manifold/ Brake fitting/ Brake pads/ Brake fluid reservoir/ Brake lever/ Brake lines/ Brake pedal/ Brake pump/ Brake disc/ Brake caliper/ Cockpit fairing/ Chassis lift/ Chassis lower/ Shock absorber(s)/ Rims/ Footrest system/ Fork/ Triple clamp/ Fork springs/ Fork stabilizer/ Gear ratio/ Master cylinder/ Center stand/ Rear lift/ Rear lower/ Rear fairing/ Rear wheel cover/ Sprocket (if the number of teeth is not identical)/ Fender/ Manifold (only if the pipe routing or cross-section changes)/ Headlight mask/ Handlebar/ Bar-end indicators (on current motorcycles only in conjunction with a rear pair of indicators)/ Handlebar clamps (risers)/ Steering damper/ Air filter/ Air filter insert (if the air flow changes)/ Air filter box/ Tires (if the dimensions change)/ Pinion (if the number of teeth is not identical)/ Swing arm/ Side stand/ Secondary gear ratio/ Seat (if there are major changes to the dimensions)/ Passenger grab handles/speedometer/fuel tank/carburetor/carburetor jets/fairing/fairing keel/fairing screen
