The LED daytime running light with 4 LEDs of 1 watts is installed in a rectangular, black aluminum housing. The powerful LEDs significantly increase the perception of motorcyclists by other road users. Including universal holder, e-tested.

See and be seen - give your bike personality! The unusual design and the perfect technology of highsider headlight series will definitely make you a sensational highlight!

Dimensions:
Width: 145 mm
Height: 40.5 mm
Depth: 66 mm

Technical specifications:
Electricity recording at 12.5 volts: only 0.3 amps (approx. 3.75 watts)
Lower stream at 12 volts: 215 lumens

Connections:
Black cable: mass (-)
Red cable = plus (+), is connected to the plus (ignition).
White cable = is connected to the control line of the Absblag

Scope of delivery: 1 piece

Note 1 - with existing light switch:
A prerequisite for the operation of the daytime running light (TFL) is a manually switched low beam (light switch), otherwise the function of the TFL would be canceled.
According to the road traffic regulations, the TFL must be connected so that it starts when the main headlights are switched on.
(Exception: pressing the light of light). The rear final lamp must always remain switched on, i.e. place on the ignition plus.

Note 2 - without existing light switch:
The daytime running lights can also be used on vehicles without a light switch. For this purpose z. B. the following components needed:
Switch: Art. No. 240/044
  DRL Control box CB1: Art. No. 208-108 (switches between low beam and daytime running lights)