Compact alarm system with two remote controls and external siren.
Designed and suitable for all moving devices with 12V power supply.
e.g. for trikes, scooters, motorcycles, quads, snowmobiles, electric bicycles, cars, campers etc.

    Very loud siren (approx. 125 dB / 1m) with self-adhesive stick and 2 mounting holes
    6-fold frequency changing alarm signal
    Vibration-dependent alarm triggering (siren sounds, ignition is interrupted and blinkers flash)
    Trigger sensitivity adjustable in 5 ways
    In the event of a 1st vibration - 5 x siren beeps (= warning to the thief - leave your fingers out - otherwise I'll scream!)
    With further vibration - very loud 6 times frequency-changing alarm signal for 10 seconds
    Integrated immobilizer through ignition interruption

2 radio remote controls as key fobs

    Switching on and off via radio remote control with acoustic and visual confirmation
    Trigger alarm and switch off alarm (use e.g. as acoustic vehicle finder)
    start the motor
    Radio transmission frequency 433 MHz
    Remote control range: up to approx. 80 m outdoors

Technical specifications:

    DC voltage required: 9V - 14V
    Standby current consumption: <6 mA

Dimensions:

    Alarm system: 80 mm x 65 mm x 30 mm (L x W x H)
    Antenna wire length: 25cm (color: blue)
    Connection cable length: 10 cm with 8 pin plug
    Connection cable length: 50 cm with 8 pin coupling
    Plus cable with flying 15 A fuse
    Earth cable length: 30 cm
    Siren connection cable length on the alarm system with 2-pin connector: 15 cm (color: red and black)
    Siren connection cable length with 2-pin connector: 40 cm (color: red and black)
    Siren: diameter 55 mm, height 30 mm and sprue 40 mm x 10 mm
    Siren: 2 mounting holes (5 mm) with a distance of 30 mm to each other.

Even if only the + and - cables are connected, the siren of the alarm system is already working. The alarm of the siren is triggered by the vibration sensor. The turn signal and ignition interruption are then not active.

Alarm systems consume electricity both when switched on and in standby mode. Therefore, if the alarm system is installed, ensure that the battery is sufficiently charged.
This alarm system does not work on vehicles with 6 V or AC electrical systems!

You can find operating and installation instructions for this universal alarm system on our website.